- ページ 4

無線アクセスポイント Cisco 3800 SeriesのPDF 設定をオンラインで閲覧またはダウンロードできます。Cisco 3800 Series 32 ページ。 Password recovery procedure
Cisco 3800 Series にも：データシート (8 ページ), アプリケーションノート (41 ページ), トラブルシューティングマニュアル (15 ページ), データシート (20 ページ), クイック・スタート・マニュアル (40 ページ), ユーザーマニュアル (7 ページ)

How to Configure Radio Settings on an Access Point

•

Configuring Universal Client Mode

Perform this task to configure universal client mode.

You can configure universal client mode on a Cisco ISR series router by setting the radio interface station

role to nonroot. This is different from configuring the dot11radio interface to operate in non-root bridge

mode, which requires specifying the word bridge at the end of the command, for example, station-role

non-root bridge.

In other Cisco wireless products such as the Cisco AP1232, the station-role non-root command

Note

operates the same as station-role non-root bridge command. On the ISRs, the two commands are

different: station-role non-root is considered the universal client mode and station-role non-root

bridge is considered the nonroot bridge mode.

SUMMARY STEPS

Configuring RTS Threshold and Retries on an Access Point, page 22

Configuring Maximum Data Retry on an Access Point, page 24

Configuring Packet Fragmentation Threshold on an Access Point, page 25

Configuring IP Phone Support on an Access Point, page 26

enable

configure terminal

interface dot11Radio interface

station-role {root [access-point | ap-only | bridge [wireless-clients]] | non-root [bridge]}

end

copy running-config startup-config

Configuring Radio Settings on an Access Point

(optional)