- ページ 19

無線アクセスポイント Cisco 500 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 500 Series 25 ページ。 Stackable managed switches
Cisco 500 Series にも：安全情報マニュアル (42 ページ), マニュアル (4 ページ), クイック・スタート・ガイド (13 ページ), クイック・スタート・マニュアル (21 ページ), データシート (5 ページ), ユーザーマニュアル (4 ページ), ユーザーマニュアル (6 ページ), ユーザーマニュアル (46 ページ), マニュアル (40 ページ), 管理マニュアル (48 ページ), マニュアル (24 ページ), トラブルシューティングとメンテナンス (15 ページ), クイック・リファレンス・マニュアル (7 ページ)

Gigabit LED (if present)—(Green) Located on the right of a GE port. Lights

steady when another device is connected to the port, is powered on, and a

1000 Mbps link is established between the devices. When the LED is off,

the connection speed is under 1000 Mbps or nothing is cabled to the port.

SFP (if present)—(Green) Located on the right of a GE port. Lights steady

when a connection is made through the shared port. Flashes when the port

is passing traffic.

Reset Button

The switch can be reset by inserting a pin or paper clip into the reset

button opening on the front panel of the switch. See

to the Factory Default Settings and Troubleshooting

The power port and console port are located on the back panel of the

switch.

Power—Connects the switch to AC power.

Console—Connects a serial cable to a computer serial port so that it can

be configured by using a terminal emulation program.

Returning the Device to the Factory

Default Settings and Troubleshooting

To use the

Reset

• To reboot the switch, press and hold the

seconds.

• To restore the switch configuration to the factory default settings:

1. Disconnect the switch from the network or disable all DHCP servers

on your network.

2. With the power on, press and hold the

10 seconds.

500 Series Stackable Managed Switches

button to reboot or reset the switch, do the following:

Returning the Device

for details.

Reset

button for less than 10

Reset

button for more than