- ページ 9
無線アクセスポイント Cisco 800 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 800 Series 17 ページ。 Fast step software design guide
Cisco 800 Series にも： リリースノート (36 ページ), クイック・スタート・マニュアル (13 ページ), 設定 (32 ページ), 設計マニュアル (50 ページ)
ページを印刷する
9
Connect the Power and Turn On the Router
Follow these steps to connect power to the Cisco 800 series router and turn it on.
Figure 6
Connecting the Power to an 800 Series Router
HU B
NO HU B
0
To electrical outlet
Make sure the router power is off.
Step 1
Step 2
Set the power switch to the STANDBY (
Step 3
Connect the power supply cable to the 8-pin connector on the router.
Connect the power cord to the desktop power supply.
Step 4
Connect the other end of the power cord to an electrical outlet.
Step 5
Turn ON the router. Press the power switch to on (|).
Step 6
10
Verifying the LEDs
Verify the power connection and all other connections (links) by checking the LEDs in the table below. If the LEDs are not on,
see the troubleshooting information in the Cisco 800 Series Routers Hardware Installation Guide.
Power/Link
Power
To hub, server, PC, or workstation
To ISDN network using ISDN S/T port LINE, CH1, or CH2
To ISDN network using ISDN U port
To telephone, fax, or modem
C is c o 8
ET HE RN
0 3
ET 10 BA
SE T
CO NS OL
E
IS DN S/
T
1
PH ON E
2
3
1
2
Desktop power supply
LEDs To Check
OK
Cisco 801 or Cisco 802 back panel:
LINK LED
Cisco 803 or Cisco 804 front panel:
LKØ, LK1, LK2, and LK3 LEDs
NT1, LINE, CH1, or CH2
PH1 or PH2
You can also pick up the handset and
listen for a dial tone.
) position.
Normal Patterns
On
On
On. CH1 or CH2 is on only when the router
has an active voice or data connection.
On. CH1 or CH2 is on only when the router
has an active voice or data connection.
On. PH1 or PH2 is on only when telephone,
fax, or modem is in use.
9