- ページ 8

無線アクセスポイント Cisco AIR-AP1042N-E-K9のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco AIR-AP1042N-E-K9 35 ページ。

Access points mounted in a building's environmental airspace must be powered using PoE

Note

to comply with safety regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the

device MAC addresses from each location and return them to the person who is planning or managing

your wireless network.

Installation Summary

Installing the access point involves these operations:

• Performing a pre-installation configuration (optional)

• Mounting the access point

• Grounding the access point

• Deploying the access point on the wireless network

The following procedures ensure that your access point installation and initial operation go as

expected. A pre-installation configuration is also known as priming the access point. This procedure

is optional.

Performing a pre-installation configuration is an optional procedure. If your network

Note

controller is properly configured, you can install your access point in its final location and

connect it to the network from there. See the "Deploying the Access Point on the Wireless

Network" section on page 14 for details.