- ページ 3

無線アクセスポイント Cisco AIR-AP1141N-E-K9のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco AIR-AP1141N-E-K9 37 ページ。 Autonomous access point

Warning

Installation of the equipment must comply with local and national electrical codes.

Statement 1074

Warning

This product relies on the building's installation for short-circuit (overcurrent)

protection. Ensure that the protective device is rated not greater than:

20A. Statement 1005

Warning

Do not operate your wireless network device near unshielded blasting caps or in an

explosive environment unless the device has been modified to be especially qualified for

such use. Statement 245B

Warning

In order to comply with FCC radio frequency (RF) exposure limits, antennas should be

located at a minimum of 7.9 inches (20 cm) or more from the body of all persons.

Statement 332

When mounting the access point to a wall or ceiling, be sure to use appropriate fasteners.

Caution

The fasteners used must be capable of maintaining a minimum pullout force of 20 lbs (9

kg) and must use all 4 indented holes on the low-profile mounting bracket.

Caution

This product and all interconnected equipment must be installed indoors within the same

building, including the associated LAN connections as defined by Environment A of the

IEEE 802.af Standard.

The access point is suitable for use in environmental air space in accordance with section

Note

300.22.C of the National Electrical Code and sections 2-128, 12-010(3), and 12-100 of the

Canadian Electrical Code, Part 1, C22.1. You should not install the power supply or power

injector in air handling spaces.

Use only with listed ITE equipment.

Note