- ページ 3
無線アクセスポイント Cisco AIR-LAP1141N-A-K9 - Aironet 1141 - Wireless Access PointのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco AIR-LAP1141N-A-K9 - Aironet 1141 - Wireless Access Point 35 ページ。 Lightweight access point
ページを印刷する
Warning
This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that the protective device is rated not greater than:
20A. Statement 1005
Warning
Do not operate your wireless network device near unshielded blasting caps or in an
explosive environment unless the device has been modified to be especially qualified for
such use. Statement 245B
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be
located at a minimum of 7.9 inches (20 cm) or more from the body of all persons.
Statement 332
When mounting the access point to a wall or ceiling, be sure to use appropriate fasteners.
Caution
The fasteners used must be capable of maintaining a minimum pullout force of 20 lbs (9
kg) and must use all 4 indented holes on the low-profile mounting bracket.
This product and all interconnected equipment must be installed indoors within the same
Caution
building, including the associated LAN connections as defined by Environment A of the
IEEE 802.af Standard.
Note
The access point is suitable for use in environmental air space in accordance with section
300.22.C of the National Electrical Code and sections 2-128, 12-010(3), and 12-100 of the
Canadian Electrical Code, Part 1, C22.1. You should not install the power supply or power
injector in air handling spaces.
Use only with listed ITE equipment.
Note
3