- ページ 7

無線アクセスポイント Cisco Aironet 350 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Aironet 350 Series 12 ページ。 Managed switches
Cisco Aironet 350 Series にも：クイック・スタート・マニュアル (12 ページ), リリースノート (14 ページ), クイック・スタート・マニュアル (16 ページ), クイック・スタート・マニュアル (12 ページ), クイック・スタート・マニュアル (2 ページ), マニュアル (10 ページ), 知る (16 ページ), クイック・スタート・マニュアル (5 ページ)

3 Associate an IP Address With the Bridge (continued)

Note IPSU can change the IP address and SSID only from their default settings. After these

values are changed, the utility cannot change them again unless you reset the configuration

to factory defaults. To do so, click Reset All System Factory Defaults on the System

Configuration Setup page in the bridge management system.

Step 1

Double-click the IPSU icon on your computer desktop to start IPSU. The following screen

appears:

Step 2

Make sure Set Parameters is selected in the Function box.

Step 3

In the Device MAC ID field, enter the MAC address as it appears on the label on the bottom

of the bridge. It should contain six pairs of hexadecimal digits. For example, your bridge's

MAC address might look like this: 00409625854c

In the IP Address field, enter the IP address to be assigned to the bridge. It should be provided

Step 4

by your system administrator.

In the SSID field, enter the case-sensitive SSID provided by your system administrator. All

Step 5

bridges in the same radio network must use the same SSID.

Note You cannot set the SSID without also setting the IP address. However, you can

set the IP address without setting the SSID.

Click the Set Parameters button.

Step 6