- ページ 6
ペットケア製品 Cabela's GS-2001Gun Dog SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cabela's GS-2001Gun Dog Series 11 ページ。 Remote trainer
ページを印刷する
Match the Collar Receiver and
Remote Transmitter
To reset the Collar Receiver to work
with a new Remote Transmitter or to
reprogram a new Collar Receiver to
work with your existing Remote
Transmitter:
1. Turn the Collar Receiver off.
2. Press and hold the On/Off Button.
The Collar Receiver Indicator Light
will come on, then turn off after 5-6
seconds. If the On/Off Button is
released too early, the Collar
Receiver Indicator Light will begin
flashing as normal. If this occurs,
start over and repeat from 1.
3. After the Collar Receiver Indicator
Light has turned off, release the
On/Off Button.
4. Press and hold the Upper Button
on the Remote Transmitter until the
Collar Receiver Indicator Light
flashes 5 times. You may need to
hold both units 2-3 feet from each
other before this occurs. Once the
Collar Receiver Indicator Light has
flashed 5 times, the Collar Receiver
has been reset and will begin
flashing as normal. If the Collar
Receiver Indicator Light does not
flash 5 times, start over and repeat
from 1.
Two Dog Systems
If you wish to add another Collar
Receiver to the training system,
accessory Collar Receivers are
available through Cabela's catalog,
retail stores, or website.
10
1. Holding the second Collar
Receiver, set your Transmitter to
Dog 2 (Dog Select button), and
repeat the above steps 1-4.
The Transmitter sends signals to the
Collar Receiver of the dog symbol
appearing in the Transmitter display.
To switch between Collar Receivers,
press the Dog Select button until the
desired dog symbol displays.
Dog 1 symbol
Dog 2 symbol
Cabela's
®
Gun Dog
®
— Owner's Manual
Testing the Collar Receiver
In order to make sure the Collar
Receiver is getting signals from the
Transmitter, you may wish to test the
Collar Receiver from time to time.
To test:
1. Hold the included Test Light
across the Collar Receiver's
contacts. (The holes in the Test
Light go over the contact tips;
make sure the wire inside the hole
touches the contact tip.)
2. Press the Stimulation button on
the Transmitter.
3. The Test Light lights up. The
intensity of the Test Light
depends on the stimulation level.
The light is dim for low stimulation
levels and is brighter with higher
stimulation levels.
Cabela's
®
Gun Dog
®
— Owner's Manual
TRAINING
Always start training your dog with
the lowest stimulation, and increase
to a higher level only if necessary. You
will know when you've reached the
right level when your dog responds
by twitching his head, neck, or
shoulders, or by perking up his ears.
If the dog vocalizes, you need to go
to a lower level.
Over-Stimulation Protection
The Transmitter can transmit
continuously (Tone or Stim) for up to
10 seconds. If you attempt to
transmit continuously for more than
10 seconds, the transmitter enters a
10 second lockout mode during
which time no transmissions are
allowed (hence, no stimulation
allowed).
Training Tone Option
The Tone button causes the collar to
produce a sound. No stimulation is
delivered when the Tone button is
pressed. The tone continues for as
long as the button is held down, up to
10 seconds. A tone can help
strengthen a dog's response to
training. The tone can be used as a
warning tone prior to pressing the
stimulation button; or can be a reward
tone when presented with praise,
play, or food for good behavior.
The use of a training tone is optional.
Its use varies among popular training
methods. Some trainers choose to
use the tone option as a warning tone
prior to stimulation, others prefer to
11