5
Press the
6
Press the
the
button.
7
Press the
8
For each of the following settings, press the
then press the
When done press the
•
IP Address
•
Subnet Mask
•
Gateway
See the next section to install the software on each computer that will be using
the CX11N on the network.
Install and Configure the Client Software (Windows Only)
Note: For Mac OS X 10.2.4 or later, see the Basics Guide for information on
setting up a Macintosh computer to connect to the CX11N over a network.
Install Software
1
Insert the Epson CD-ROM into the CD drive of your computer.
2
Make sure you close all other applications.
When you see the following screen, click
Continue.
3
Read the license agreement that
appears and click Agree.
4
For the type of installation,
select Local.
5
Select Custom.
6
Select the following:
•
EPSON Scan
•
Printer Driver
•
EPSON Status Monitor 3
•
User's Guide
Then click Install.
7
Follow the prompts to install
the software.
Note: If you are asked to restart your computer,
click No.
8
When the Epson Printer Utilities Window appears,
select EPSON AL-CX11 Advanced and click OK.
9
When you see this screen, select Manual, then
select LPT1 as the printer port and click OK.
10
Select your country or region, then click OK.
11
When you are done installing the software, click
Exit and remove the CD from your computer's
CD-ROM drive.
Add Port
1
From the Windows Start menu, select Settings > Printers and Faxes.
2
Right-click EPSON AL-CX11 Advanced and select Properties.
3
Select the Ports tab, then click Add Port.
4
Select Standard TCP/IP, then click New Port.
The Add Standard TCP/IP Port Wizard appears.
5
Click Next.
6
Enter the IP Address that was assigned, then click Next.
7
Click Finish.
8
Select the IP address in the Ports list, then click Apply.
9
Restart your computer.
button until Yes is selected, then press the
button until Get IP Address is selected, then press
button until Panel is selected, then press the
button. Use the
button.
button until it is selected,
and
buttons to set the numbers.
button.
button.
ページを印刷する