- ページ 27

無線アクセスポイント Cisco ASA 5508-XのPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco ASA 5508-X 32 ページ。 Threat defense reimage guide
Cisco ASA 5508-X にも：クイック・スタート・マニュアル (8 ページ), 簡単セットアップマニュアル (11 ページ), クイック・スタート・マニュアル (9 ページ), ソフトウェアマニュアル (37 ページ), マウント＆コネクト (6 ページ), マニュアル (14 ページ)

Mount and Connect

You can configure any of the Gigabit Ethernet interfaces to be a management-only interface using the

management-only command. However, you cannot disable management-only mode on the Management 1/1 interface.

The following figure shows how to connect the network cables.

Figure 19: ASA 5508-X and ASA 5516-X Cabling

Gigabit Ethernet data interface (RJ-45)

Management 1/1 interface (RJ-45)

b) (Optional) Console port – For use with the CLI. Connect a computer or terminal server using a serial console cable

to either the RJ-45 or Mini USB Type B port.

Only one console port can be active at a time. When a cable is plugged into the USB console port, the RJ-45 port

becomes inactive. Conversely, when the USB cable is removed from the Mini USB Type B port, the RJ-45 port

becomes active. See

console port.

c) Gigabit Ethernet ports – For the network interfaces; use standard RJ-45 Ethernet cables.

You can use any available Gigabit Ethernet port on the ASA 5508-X or ASA 5516-X as a failover link. The failover

link interface is not configured as a normal networking interface; it should only be used for the failover link. You

can connect the failover link by using a dedicated switch with no hosts or routers on the link.

Online Only

Connect to a Console Terminal or PC, on page 24

Connect Cables, Turn on Power, and Verify Connectivity

Console port (RJ-45 or Mini USB Type B)

for specific instructions for connecting the

Cisco ASA 5508-X and ASA 5516-X Hardware Installation Guide