- ページ 8

無線アクセスポイント Cisco Meraki CW9163EのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Meraki CW9163E 28 ページ。

Mounting posts D (4x)

The mounting posts are located in the middle of the MA-MNT-MR-16 mounting plate, secure the CW9163E to the mounting plate via mounting slots on the AP.

Horizontal orientation mounting strap slots E (2x)

The horizontal orientation mounting strap slots located in the middle of the MA-MNT-MR-16 mounting plate secure the mounting plate to a horizontal pole using

the included mounting straps.

Release tab F

The release tab is located at the bottom of the MA-MNT-MR-16 mounting plate. Press down the release tab to when detaching the AP to unlock.

Safety and Warnings

These operations are to be taken with respect to all local laws. Please consider the following for safe operation:

•

Power off the unit before you begin. Read the installation instructions before connecting the system to the power source.

•

Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing

accidents.

•

Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware or to follow the correct procedures could

result in a hazardous situation to people and damage to the system.

•

This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than 15 A,

125 Vac, or 10A, 240 Vac.

•

Please only power the device with the provided power cables or standard PoE to ensure regulatory compliance.

Pre-Install Preparation

You should complete the following steps before going on-site to perform an installation.

Configure Your Network in Dashboard

The following is a brief overview of the steps required to add a CW9163E to your network. For detailed instructions about creating, configuring, and managing

wireless networks, refer to the online documentation (documentation.meraki.com/mr).

Find the network to which you plan to add your APs or create a new network.

Add your APs to your network. You will need your Cisco Wireless order number (found on your invoice) or the serial number of each AP, which looks like

Qxxx-xxxx-xxxx, and is found on the bottom of the unit. You will also need your Enterprise license key, which you should have received via email.

Go to the map / floor plan view and place each AP on the map by clicking and dragging it to the location where you plan to mount it.

Check and Upgrade Firmware

To ensure your CW9163E performs optimally immediately following installation, it is recommended that you facilitate a ﬁrmware upgrade prior to mounting your

CW9163E.