- ページ 19

無線アクセスポイント Cisco Meraki CW91641-MRのPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Meraki CW91641-MR 23 ページ。

4.4 Verify Device Functionality and Test Network Coverage

1. Check LEDs

The LED should be solid white. If it is flashing orange, the firmware is automatically upgrading and

the LED should turn green when the upgrade is

Note: Your CW9166I‐MR, CW9164I‐MR must have an active route to the Internet to check and upgrade its

firmware.

2. Verify access point

Use any 802.11 client device to connect to the CW9166I‐MR, CW9164I‐MR and verify proper connectivity using

the client's web browser.

3. Check network coverage

Confirm that you have good signal strength throughout your coverage area. You can use the signal strength

meter on a laptop, smart phone, or other wireless device.

Troubleshooting

Reference the Meraki knowledge base at http://meraki.com/support/knowledge_base for additional information

and troubleshooting tips.

Regulatory

FCC Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This de‐

vice may not cause harmful interference, and (2) this device must accept any interference received, including

interference

hat may cause undesired operation.

FCC Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residen tial installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to correct the interference by one of the following

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

Any changes or modifications no expressly approved by Meraki could void the user's authority to operate this

equipment. This Transmitter must not be co‐located or operation in conjunction with any other antenna or

transmitter.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance 41 cm between the radiator and your body.

connectivity

completed (normally in under thirty minutes).

measures: