無線アクセスポイント Cisco Meraki MR12のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Meraki MR12 3 ページ。 Assigning static ip addresses

Assigning Static IP Addresses to an MR12 or MR58

The

MR12

and MR58 wireless access points have two Ethernet ports that can be used to connect the device to a wired network. However, a static IP can only

be set on the primary Ethernet interface.

This article will discuss:

• Identifying the primary Ethernet port

• Behavior differences between primary and secondary ports

• Determining which port is being used

•

Assigning a static IP

Identifying the Primary Ethernet Port

MR12

The primary Ethernet port is directly adjacent to the power connector and is labeled as Uplink.

MR58

The primary Ethernet port is located on the bottom-left side of the AP and is labeled as ETH0.