- ページ 9

無線アクセスポイント Cisco Meraki MR36のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Meraki MR36 19 ページ。

Static Assignment

• Static IPs are assigned using the local web server on each AP. The following procedure describes how to set the

static IP:

• Using a client machine (e.g., a laptop), connect to the AP wirelessly (by associating to any SSID broadcast by the

AP) or over a wired connection.

• If using a wired connection, connect the client machine to the AP either through a PoE switch or a PoE Injector. If

using a PoE switch, plug an Ethernet cable into the AP's Ethernet jack, and the other end into a PoE switch. Then

connect the client machine over Ethernet cable to the PoE switch. If using a PoE Injector, connect the AP to the

"PoE" port of the Injector, and the client machine to the "LAN" port.

• Using a web browser on the client machine, access the AP's built-in web server by browsing

to http://my.meraki.com. Alternatively, browse to http://10.128.128.128.

• Click on the "Uplink Conﬁguration" tab. Log in. The default login is the serial number (e.g. Qxxx-xxxx-xxxx), with no

password (e.g., Q2DD-551C-ZYW3).

• Configure the static IP address, net mask, gateway IP address and DNS servers that this AP will use on its wired

connection.

• If necessary, reconnect the AP to the LAN.

Static IP via DHCP Reservations

• Instead of associating to each Meraki AP individually to configure static IP addresses, an administrator can assign

static IP addresses on the upstream DHCP server. Through "DHCP reservations," IP addresses are "reserved" for

the MAC addresses of the Meraki APs. Please consult the documentation for the DHCP server to conﬁgure DHCP

reservations.

Collect Tools

You will need the following tools to perform an installation:

You will need the following hardware to perform an installation: