- ページ 15

無線アクセスポイント Cisco Meraki MR46EのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Meraki MR46E 19 ページ。

To release the AP from the mount cradle, first remove the security screw that secures the MR46E AP to the cradle's

bottom tab. While holding the MR46E AP with one hand, press the cradle's bottom tab upwards, releasing the MR46E

AP from the bottom of the cradle. Then remove the MR46E AP from the cradle's top tab.

Desk or Shelf Mount

The access point can both be placed on a desk or shelf resting on the non-scratch rubber feet. The mount cradle is not

necessary for a desk or shelf installation.

Physical Security

Depending on your mounting environment, you may want to secure the AP to its mount location. The access point can

both be secured in several ways. If the AP has been installed using the mount cradle, it should be secured via security

screw (Torx security screws are included) and/or Kensington lock. If the mount cradle was not used, the AP can still be

secured using a Kensington lock.

Security Screw

The accessory kit includes screws that can be used to secure the access point to the mount cradle. Engaging the

security screw prevents accidental dislodging and theft.

Kensington Lock

The access point contains a hard point that allows it to be secured to any nearby permanent structure using a standard

Kensington lock. Attach a Kensington lock cable to the access point at the hard point on the side of the device. Attach

the other end of the cable to a secure location, such as a pipe or building ﬁxture.

Verify Device Functionality and Test Network Coverage

1. Check LEDs

a. The Power LED should be solid green (or blue, if clients are connected). If it is ﬂashing blue, the ﬁrmware is

automatically upgrading and the LED should turn green when the upgrade is completed (normally within a

few minutes). See the

b. Note: Your AP must have an active route to the Internet to check and upgrade its ﬁrmware.

"LED

Indicators" section for more details. .