- ページ 9

無線アクセスポイント Cisco Meraki MR70のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Meraki MR70 14 ページ。 Cloud-managed access point
Cisco Meraki MR70 にも：インストレーション・マニュアル (12 ページ)

ページを印刷する

Wall or Solid Ceiling Mount Using Mount Cradle

Using included wall anchors and screws, attach the mount cradle to your mounting wall or ceiling. It is

recommended that the MR70 be mounted to a wall or solid ceiling using the mount cradle for physical security

reasons.

Pole Mount Using Mount Cradle

Use mounting straps (not included) to secure the mount cradle to a pole. Thread the mounting straps through the

mounting strap slots to secure the mount plate in a horizontal or vertical orientation. Vertical orientation is

recommended for optimal RF coverage.

Connect Access Point to Ethernet and/or AC Adapter

Using a phillips head screwdriver, remove the screws that secure the Ethernet cover. Ensure that the Ethernet cable

(and power cable, if applicable) is properly secured in the black cable gland. Secuire the Ethernet cover with the phillips

head screwdriver.

Mount the MR70

Attach the MR70 to the Mount Cradle

(This section applies to wall and/or solid ceiling where you have already installed the mount cradle.)

The MR70 attaches to the mount cradle with two tabs on the cradle that insert into the MR70, and is secured to the

cradle using one screw.

To attach the MR70 to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle.

Since the cradle is already mounted to the wall, guide the MR70 towards the top tab and insert the top tab into the

MR70's slot.

Then, adjust the MR70 to guide the MR70's bottom slot into the cradle's bottom tab until it clicks into place. Once in

place, the MR70 should be secured to the cradle by using one of the included screws in the cradle's bottom tab.