- ページ 7

無線アクセスポイント Cisco MR53のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco MR53 17 ページ。 Dual-band enterprise class 802.11ac wave 2 cloud-managed access point

ページを印刷する

Pre-Install Preparation

You should complete the following steps before going on-site to perform an installation.

Conﬁgure Your Network in Dashboard

The following is a brief overview only of the steps required to add a MR52 or MR53 to your network. For detailed

instructions about creating, conﬁguring and managing Meraki wireless networks, refer to the online documentation

(documentation.meraki.com).

1. Login to http://dashboard.meraki.com. If this is your ﬁrst time, create a new account.

2. Find the network to which you plan to add your APs or create a new network.

3. Add your APs to your network. You will need your Meraki order number (found on your invoice) or the serial

number of each AP, which looks like Qxxx-xxxx-xxxx, and is found on the bottom of the unit. You will also need

your Enterprise license key, which you should have received via email.

4. Go to the map / ﬂoor plan view and place each AP on the map by clicking and dragging it to the location where you

plan to mount it.

Check and Upgrade Firmware

To ensure your MR52 or MR53 performs optimally immediately following installation, it is recommended that you

facilitate a ﬁrmware upgrade prior to mounting your AP.

1. Attach your AP to power and a wired Internet connection. See the "Power the Ap" section for details.

2. The AP will turn on and the LED will glow solid orange. If the unit does not require a ﬁrmware upgrade, the LED

will turn either green (no clients associated) or blue (clients associated) within thirty seconds.

* If the unit requires an upgrade, the LED will begin blinking orange until the upgrade is complete, at which point the LED

will turn solid green or blue. You should allow at least a few minutes for the ﬁrmware upgrade to complete, depending on

the speed of your internet connection.

Check and Conﬁgure Firewall Settings

If a ﬁrewall is in place, it must allow outgoing connections on particular ports to particular IP addresses. The most

current list of outbound ports and IP addresses for your particular organization can be found here.

Assigning IP Addresses

All gateway MR52s and MR53s (An AP with Ethernet connections to the LAN) must be assigned routable IP addresses.

These IP addresses can be dynamically assigned via DHCP or statically assigned.