- ページ 3

無線アクセスポイント Cisco WAP571のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco WAP571 6 ページ。 Manually connect access points to the network via power over ethernet (poe)
Cisco WAP571 にも：クイック・スタート・マニュアル (15 ページ), マニュアル (4 ページ)

ページを印刷する

Step 4. Slide the Ethernet cable through Part A of the weather-proof connector.

Step 5. Insert the thin red gasket into the opening of Part B of the weather-proof connector.

Connect the WAP571E via PoE

Important: Make sure that the network you are connecting the WAP to has PoE (802.3af and

802.3at) and that your network is up and running.

Step 1. Go over the back and bottom panels of the WAP571E.

Step 2. Position the WAP571E in such a way that the label underneath the device is right side up.

Step 3. Remove the cover of the port labeled ETH0/PD to expose the Ethernet port. This can be

done by turning the cap counter-clockwise.

Note: Take care not to lose the thin rubber gasket.

Step 4. Connect the Ethernet cable into the ETH0/PD slot of the WAP571E.