- ページ 7
無線アクセスポイント Cisco Wap581のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Wap581 17 ページ。 Reboot and reset to factory default settings
Cisco Wap581 にも： クイック・スタート・マニュアル (14 ページ), マニュアル (10 ページ)
ページを印刷する
Ethernet: Left-
Green
Ethernet No.0:
Right-Green
Ethernet No.1:
Right-Green
If you need help resolving a problem, visit the Cisco Support Community at
N
OTE
www.cisco.com/go/smallbizsupport.
6
Getting Started with the Configuration
To configure the wireless access points, you can either use Ethernet or wireless.
Please follow these steps to access the Wizard and then the web-based
configuration utility from your computer by Ethernet:
Ethernet: Connect the wireless access point to the same network (IP subnet)
S
1
TEP
as your computer. The factory default IP address configuration of the
access points is DHCP. Make sure your DHCP server is running and can be
reached.
See
Incorrect IP Address, page10
you do not have a DHCP server.
Wireless: Search the wireless SSID "CiscoSB-Setup", and connect to this
SSID with the passphrase "cisco123".
Locate the IP address of the wireless access point.
S
2
TEP
Cisco WAP125 Quick Start Guide
Solid (Green)
Flashing (Green)
Solid (Blue)
Flashing (Blue)
Solid (Red)
Flashing cycle
with Green and
Blue
Off
Solid Green
Flashing Green
Off
Solid Green
Off
Solid Green
The Cisco WAP581 is normal; no wireless client
connected.
The device is booting.
The Cisco WAP581 is normal; at least one
wireless client connected.
The Cisco WAP581 is upgrading the firmware.
The Cisco WAP581 fails to boot with both
firmware images.
Indicates the availability of new firmware
updates for the hardware that can be
downloaded from Cisco.com
No Ethernet link.
Ethernet link is active.
Transmitting or receiving data.
Gigabit Ethernet Link is active
2.5Gigabit Ethernet Link is active
Fast Ethernet Link is active
Gigabit Ethernet Link is active
for troubleshooting information, or if
7