ページを印刷するFIG. A
Pan splash
guard
Hand rest
1. Refer to FIG. A for assembly. Determine a suitable, well lit location to place your
CabKing-6V3. The machine weighs about 45lbs. You need a sturdy table or stable surface that
has 3 feet width by 2 feet depth of clear space.
2. Open the box and remove all loose foam and accessories. Keep this packaging aside should
you need it in the future. Remove the unit from the box by lifting the machine straight up by
its baseboard and place on the predetermined location. Do not lift the machine by its hoods
or lamp. We recommend that two people help in performing this step. As an option, you can
keep the foam that is under the baseboard in place as it will aid in support and vibration.
Please note that the baseboard has a rectangular rubber on the bottom so the machine will
not sit completely flat.
3. Check to make sure all parts are present both on the machine and in the accessory box
according to the parts list on pages 6 and 7. If you find any missing or damaged parts, call us
immediately at (630) 366-6129 or email us at [email protected].
4. To complete the left wheel assembly, you need to install the 80# and 220# grinding wheels
that are included in your accessory box. Do this by removing the lap adapter on the left shaft
with the supplied flange wrench, turning clockwise. Remove the two 3/4" spacers. Leave the
1" spacer on the shaft. Slide the 220# wheel onto the left shaft, ribbed side facing the motor.
Then slide the two 3/4" spacers on next. Finish by sliding the 80# wheel onto the left shaft,
ribbed side facing the motor, and tighten the lap adapter, turning counter-clockwise using the
flange wrench. Upon completion of the left wheel assembly set-up, there should be two 3/4"
spacers between the 80# and 220# wheels and one 1" spacer between the 220# and 280#
wheels.
ASSEMBLY INSTRUCTIONS
Stone tray
80#
220#
Pan splash guards
Stone tray
8
Pan splash
guard
Hand rest