ページを印刷する10. Place the two drip pans on the baseboard. The drip pans are not fixed in place,
allowing you to move them as needed. Insert the left and right stainless steel hoods
into the grooves located inside the drip pans.
11. Place the clear stone trays on top of the hoods and insert the hand rests into the drip
pans. Secure the pan splash guards onto both sides of the drip pans. Adjust the
position of the pan splash guards according to the water splash.
12. Attach the stainless steel, inner side panels to the hoods. They
magnetically attach for easy installation. Install one side panel
on the left hood and the other on the right hood, closest to the
motor (FIG. E).
13. Optionally, attach the outer side panels to the hoods. Like the
inner side panels, they magnetically attach for easy installation.
Install one side panel on the left hood and the other on the right
hood, furthest from the motor (FIG. F). Simply move the black
side spray tube upwards to attach and remove the side panels.
These outer side panels help control the water splash, however
not installing them provides easier access to the diamond lap
and canvas pad.
SETTING UP THE WATER SYSTEM
The CabKing-8V1 water system is a single-pass system, meaning not re-circulating. DO
NOT SET-UP THE WATER SYSTEM AS A RE-CIRCULATING SYSTEM. Read further
about the CabKing water system on page 15 after set-up.
14. Slide the drip pan tubes into the drip pans. Secure the connection
with the spring clip (FIG. G). Tug on the tubes slightly to make
sure they are secured. Place the unconnected ends of the tubes
in a large, 5 gallon empty bucket (not included), drain hole, or
wherever you want the dirty water to drain out. You must have
the drip pan tubes pointing downward to allow gravity to drain
the water from the drip pans.
downward, the drip pans will fill up with water.
15. MAKE SURE WATER PUMP IS NOT CONNECTED TO POWER
SUPPLY. Connect the water intake system by pushing the two
clear tubes installed in the hoods into the black T-junction,
located on the end of the clear tube connected to the water pump
(FIG. H). Remove the protective backing from the T-junction and
place the sticky, adhesive side to the baseboard, behind the
motor. Tug on these tubes slightly to make sure they are
secured. Place the water pump in a separate, large 5 gallon
bucket (not included) filled fully with clean water (FIG. I). The
length from the bucket to the unit should not be more than 6 feet.
If the tubes aren't angled
9
FIG. E
FIG. F
FIG. G
FIG. H
FIG. I