ページを印刷する
Movement Sensor:
How to Assemble
Screws B
1) Take out the internal wire
from the sheathing.
2) Shorten the sheating 36
m/m
3) Insert both ends of the
sheathing in the clamps and
tight the 4 screws B
4) Loosen the 4 screws (A)
and insert the internal wire.
Do not tight the 4 screws A*.
*
Attention: when you insert the
internal wire, the dummy shaft must
come out and be dispose off.
A) Re-assemble the trasmission cable in the car, connecting it
to both the gear box and the odometer.
B) Drive about 100 mts to allow the internal wire to find its
original position.
C) Tight the 4 screws A.
D) Insert the sensor's prove.
E) Fix the sensor's cap to end the sensor's assembling
operation and to have the sensor fully operative.
6
The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely confidential. Any disclosure, copying, distribution to third
SENSOR
Screws A
Screws B
Clamps
Sensore Capsule
Clamps
Screw B
Screws (A)
Shaft
Electrical Connections
Red Cable
White Cable = Output Signal
Shield
party is strictly prohibited.
Sheathing
Speedometer
Cable
36 m/m
Screw B
= Power Supply
(5 Vcc to 24)
(open collector)
= Ground