- ページ 27

会議システム Cisco Codec C SeriesのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Codec C Series 42 ページ。 Telepresence conference system
Cisco Codec C Series にも：スタートマニュアル (41 ページ), ユーザーマニュアル (44 ページ), スタートマニュアル (35 ページ), スタートマニュアル (32 ページ), スタートマニュアル (46 ページ)

ページを印刷する

Cisco TelePresence Video Systems

Contents

Setting the date, time and

location

(when not set by a provisioning system)

When setting up your video conference system, you should

check that the date and time settings are correct. Among

other things this information is used to time stamp messages

transmitted to gatekeepers and other network elements.

if you operate your system using the touch controller, the time

is shown in the top right corner of the touch controller display;

if you operate your system using a remote control, the time

and date is shown in the top right corner of the main display.

If you are changing a value setting,

you have to always click

save

to confirm the change.

Back to task overview

D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.

Introduction

User interfaces

1. Go to the

Configuration

open the

2. Select your preferred date format in the

down list.

3. Select your preferred time format in the

down list.

4. Select your time zone in the

5. open the

6. under the

Mode

drop down list.*

if you select

Address

input field.

if you select Off, you have to enter the time and date

manually using either the touch controller

> Administrator Settings > Date, Time &

remote control and on-screen menu system

Settings > Date and

* NtP mode:

Auto:

the time is regularly updated using an NtP server. the

NtP server address is automatically obtained from the

network (dHCP).

Manual: the time is regularly updated using an NtP server. You

must manually enter the NtP server address.

Off:

You must set the time manually. the time is not

updated automatically.

Confirguration

Configuration

tab and select

System

Configuration.

Time

settings from the left column.

DateFormat

TimeFormat

Zone

drop down list.

NetworkServices

settings from the left column

NTP

section.select Auto,

Manual

Off

Manual,

enter the NtP server address in the

(More > Settings

Location) or the

(Home >

Time).

Appendices

drop

in the

Getting Started Guide

Contacts