- ページ 3

エアコン Argo AW726CLFのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo AW726CLF 16 ページ。

Argo AW726CLF 取扱説明書

NAME OF PARTS AND OPERATION SELECTOR SWITCH

3
4
2
1
12
3
1
1. Remote control unit.
2. Remote control sensor: Detects the room temperature
around the remote control unit, the air conditioner is
controlled accordingly.
3. Air outlet: Conditioned air is blown out of the air
conditioner through the air outlet.
4. Air intake: Air from the room is drawn into this section
and passes through air filter which removes dust.
5. Remote control receiver: This section picks up infrared
signals from the remote control unit (Transmitter).
6. Operation selector (without remote control): Push
the button to walk through the operation modes:
COOLING Models
OFF and COOL
HEAT PUMP Models
OFF, COOL and HEAT
WARNING
The OFF position does not disconnect the power. Use
the main power switch to turn off power completely.
7. OPERATION lamp: This lamp lights up during operation.
It blinks once to announce that the remote control signal
has been received and stored. It blinks continuously
during the protection modes (defrosting, etc.).
6
5
7
9
8
7
8
7 8
9
5
14
13
10
2
5
4
3
5
1
9
11
4
8. STANDBY lamp: This lamp lights up when the air
conditioner is connected to the power and ready to
receive the remote control command.
9. TIMER lamp: This lamp lights up when the system is
being controlled by the timer.
10.Air intake latch, on two sides.
11.Air filter.
12.Suspension brackets.
13.Refrigerant couplings.
14.Condensate drain connection.
15.Sensor: Detects the room temperature around the unit;
when the remote control unit is not active the air
conditioner will be set by the detected temperature.
COOLING Models
NOTE
The blinking of OPERATION, TIMER and STANDBY
lamps, indicates that the operating mode selected is not
compatible with the unit. If this happen the air
conditioner does not operate until the correct mode is
selected.
3
2
6
15
6
7
9
8
only
GB
5