- ページ 11
会議システム Cisco MeetingPlace Audio Server 5.2のPDF アップグレードマニュアルをオンラインで閲覧またはダウンロードできます。Cisco MeetingPlace Audio Server 5.2 20 ページ。 Telepresence conference system
Cisco MeetingPlace Audio Server 5.2 にも： ユーザーマニュアル (44 ページ), スタートマニュアル (46 ページ)
ページを印刷する
During the server reboot, watch for the BIOS revision SMM5370LATUDE BIOS 1.0EA02 on the
Step 16
monitor (LILLIPUT), as shown in
verifies that the BIOS was upgraded.
Figure 11
Step 17
Remove the BIOS disk from the floppy disk drive.
Disconnect the monitor (LILLIPUT) and the keyboard from the Cisco MeetingPlace 8112 and
Step 18
disconnect the power cable to the monitor and power source.
What to Do Next
•
•
Troubleshooting BIOS Upgrade Failure
Caution
Only use the procedures in this section if the BIOS upgrade fails and the server does not reboot.
1.
2.
Verifying the BIOS Upgrade
Manually power down the Cisco MeetingPlace 8112.
Step 1
Reconnect the monitor (LILLIPUT) and keyboard to the Cisco MeetingPlace 8112.
Step 2
After the fans have stopped, wait 30 seconds; then, turn on power to the Cisco MeetingPlace 8112.
Step 3
When the server begins booting up, press F2 on the monitor (LILLIPUT) to enter setup mode.
Step 4
or
78-16489-01
BIOS Revision
If the BIOS upgrade fails and the CPU is not functional (Cisco MeetingPlace 8112 does not reboot),
proceed to the
"Troubleshooting BIOS Upgrade Failure" section on page
If the BIOS upgrade is successful and the server reboots, proceed to
Drive Software" section on page
Verifying the BIOS Upgrade
Replacing the CPU and Updating the License Keys
Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure
How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM
Figure
11. This revision appears for approximately 8 seconds and
13.
BIOS Revision
11.
"Installing the DVD-ROM
11