- ページ 23

会議システム Cisco Profile SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Profile Series 44 ページ。 Jbod on the 12g sas modular raid controller
Cisco Profile Series にも： スタートマニュアル (41 ページ), ユーザーマニュアル (44 ページ), ユーザーマニュアル (7 ページ), スタートマニュアル (35 ページ), クイック・リファレンス・マニュアル (2 ページ), 設定マニュアル (13 ページ), 設置シート (2 ページ), インストレーション・マニュアル (2 ページ), クイック・スタート・マニュアル (4 ページ), クイック・スタート・マニュアル (4 ページ), 設置マニュアル (16 ページ), スタートマニュアル (32 ページ), マニュアル (16 ページ), スタートマニュアル (42 ページ), スタートマニュアル (46 ページ)

ページを印刷する
Cisco Profile Series インストレーション・マニュアル
Chapter 2

Installing the Router

If you plan to connect a modem, provide the modem and modem cable.
Installing the Router
This section describes how to install the Cisco 800M Series ISR. The Cisco 800M Series ISR can be
installed on a table top or mounted on a wall. You can choose the type of mounting while ordering the
Cisco 800M Series ISR. The recommended clearance when horizontally mounted is 1.5 inches on both
sides for floor mount bracket clearance and 2 inches on top. Top clearance is not required but stacking
heat-dissipating objects on top of the router is not allowed. Input/Output (I/O) side clearance is needed
as it is required to access the cable connections. This section also describes how to attach external
antennas to the routers and contains the following topics:
•
•
•
•
•

Warnings

Warning
This equipment needs to be grounded. Use a green and yellow 12 to 14 AWG ground wire to connect
the host to earth ground during normal use. Statement 242
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
Do not cover or obstruct the router vents located on both sides of the router; otherwise, overheating
Warning
could occur and cause damage to the router.
Warning
Do not place anything on top of the router that weighs more than 10 pounds (4.5 kilograms), and do not
stack routers on a desktop. Excessive weight on top of the router could damage the chassis.
Do not install the router or power supplies next to a heat source of any kind, including heating vents.
Warning
Warnings, page 2-3
Installing on a Table, page 2-4
Mounting on a Rack, page 2-6
Installing the Router Ground Connection, page 2-8
Installing the Power Cord Retention Latch, page 2-9
Cisco 800M Series Integrated Services Router Hardware Installation Guide
2-3