- ページ 21

会議システム Cisco SX seriesのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco SX series 34 ページ。 Telepresence video systems
Cisco SX series にも：スタートマニュアル (33 ページ), スタートマニュアル (46 ページ)

ページを印刷する

Cisco TelePresence Video Systems



Introduction

Setup assistant

When you start the system for the first time, the setup assistant

starts

automatically.

Navigate through the setup with either a

remote control or from the touch screen.

To be able to make calls your system needs an IP address

and it needs to be registered to a service. If your system is

automatically provisioned, the IP and provisioning settings

presented in this chapter are automatically configured.

NOTE:

This guide doesn't cover information on Cisco Spark

registered systems. For more information on Cisco Spark

room systems, visit:

https://help.webex.com/community/cisco-cloud-collab-mgmt

Access the settings after initial setup

Select the gearwheel icon in the upper left corner on the home

screen and navigate to

System Information >

the setting you wish to change.

No image on external screen

If the menu doesn't show up on the screen:

•

Make sure the screen is connected and has been switched

on.

•

Make sure that the correct input is selected on the screen.

•

Make sure the remote control has batteries installed.

•

Make sure the system is switched on.

If the system has just been switched on, wait a few minutes to

allow the system to start up.

If you still can't see the on-screen menu, make sure the

monitor cable is connected to the video output connector. If in

doubt, see the installation guide for your product.

D15318.03 Video Systems Getting Started Guide CE8.2, JUNE 2016.

User interfaces

Web interface

Settings. Select

Setup assistant

Getting Started Guide

Touch

Appendices