- ページ 19

会議システム Cisco TelePresenceのPDF 管理者マニュアルをオンラインで閲覧またはダウンロードできます。Cisco TelePresence 27 ページ。 Configuring a cisco unified communications manager sip trunk with a cisco telepresence content server
Cisco TelePresence にも：パンフレット (4 ページ), 仕様 (7 ページ), インストレーション・マニュアル (4 ページ), クイック・リファレンス・マニュアル (2 ページ), マニュアル (24 ページ), 設置シート (2 ページ)

ページを印刷する

Cisco TelePresence ISDN Link

Contents

Introduction

Example with full IP infrastructure and VCS

In this example the ISDN type is Euro BRI with four BRI lines (4 x 128 kbps), the number range is

8001-8004, and the endpoint is set-up and registered to a VCS*.

Endpoint configuration

Use the Remote Control or Touch panel to configure.

Network 1 > Assignment = DHCP

SIP Profile 1 > URI 1 = [email protected]

SIP Profile 1 > Proxy 1 > Address: "sip.registrar.domain.com"

Conference 1 > DefaultCall > Protocol = SIP

Conference 1 > DefaultCall > Rate: 512 (Euro BRI 4 lines @ 128 kbps)

ISDN Link configuration

Use the serial port or SSH to configure.

xConfiguration H320 NetType: BRI

(Set network type)

xConfiguration Network 1 Assignment: DHCP

(Set network assignment)

xConfiguration Gateway SIP PeerHost: "192.168.1.100"

(Set the IP address of the endpoint)

xConfiguration ISDN BRI SwitchType: Euro

(Set the ISDN switch type)

xConfiguration ISDN BRI Interface 1 Mode: On

xConfiguration ISDN BRI Interface 2 Mode: On

xConfiguration ISDN BRI Interface 3 Mode: On

xConfiguration ISDN BRI Interface 4 Mode: On

(Enable the BRI interfaces)

xConfiguration ISDN BRI Interface 1 DirectoryNumber 1 Number: "8001"

xConfiguration ISDN BRI Interface 2 DirectoryNumber 1 Number: "8002"

xConfiguration ISDN BRI Interface 3 DirectoryNumber 1 Number: "8003"

xConfiguration ISDN BRI Interface 4 DirectoryNumber 1 Number: "8004"

(Enter your BRI numbers, this MUST be according to the ISDN network configuration.)

xConfiguration Gateway SIP PeerUri: "[email protected]"

(Set URI for the endpoint)

xConfiguration SIP Profile 1 URI: "[email protected]"

(Set URI for ISDN Link. The ISDN Link must be SIP registered)

D14954.01

ISDN Link Administrator Guide IL1.0, June 2012.

Getting started

Configuration examples

Confirm that the ISDN Link is SIP registered

• xStatus SIP

Dialling from the endpoint

From the endpoint you should now be able to dial an ISDN number using the following format:

Format: <sip uri>;x-h320number=XXXX

• Where XXXX is the ISDN number you wish to call.

• In this case, with an IP infrastructure in place, we use the SIP URI to identify the ISDN Link.

Example: [email protected];x-h320number=1234

Password protection

Combining ISDN and IP

ISDN Network

ISDN Link

xConfiguration SIP Profile 1 Proxy 1 Address: "sip.registrar.domain.com"

(Set address of SIP registrar)

Administrator guide

Appendices

C40

IP Network

* VCS = Cisco TelePresence Video Communication Server