- ページ 35

会議システム Cisco TelePresence EX SeriesのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco TelePresence EX Series 41 ページ。 Telepresence ex, mx, quick set c20, codec c, sx20 quick set, profile series video systems
Cisco TelePresence EX Series にも：スタートマニュアル (42 ページ)

ページを印刷する

Cisco TelePresence Video Systems

Contents

Call key

Press the Call key to place a

call, and to accept an incom-

ing call.

Use the Call button as a short-

cut to Recent Calls when the

Call menu is not visible.

Clear

Press the Clear key to remove

characters in a text field.

Waking up the system

To wake up the system just pick up the remote control or press any key. You may have to point the

remote control toward the system/camera to make sure it discovers you.

Home key

Press the

Home

(

) key

to open the Home menu

on screen.

D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.

Introduction

User interfaces

End call / Standby

Press the End Call key to

reject an incoming call, to

end an ongoing call or—when

idle—to go into standby mode.

When navigating in the menu

the key is used to exit the

menu system.

Press and hold this key to

have the system enter standby

mode.

Rubber line sensors

When you pick up the remote

control and touch the rubber

line sensors along the sides of

the remote control, the system

wakes up.

Configuration

Alphanumeric keypad

The keypad behaves in a similar way to the keypad on a mobile phone.

0-9, a-z, period (.), @,

space, *

Press a key repeatedly

to toggle between the

options displayed on that

key.

IR sensor range (DIP switch setting)

The IR sensor has a short and long range. When video conference systems are placed close to each

other, you may find it convenient to use the short range to avoid interfering with the other systems.

Open the battery cover and remove the batteries to set the DIP switch.

• Short range (1 m / 3 ft): Move the DIP switch down.

•

Long range: Move the DIP switch up.

The DIP switch

Getting Started Guide

Appendices

Contacts

Press and hold the # key

to toggle between lower

and upper case characters

and numbers (depending

on context).

abc/123 #