- ページ 2

コンピュータ・ハードウェア DigiTech RPX400のPDF ソフトウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。DigiTech RPX400 12 ページ。 Usb drivers and software installation guide
DigiTech RPX400 にも：マニュアル (6 ページ), トラブルシューティングマニュアル (6 ページ)

ページを印刷する

Congratulations on your purchase of a DigiTech RPx400. This installation guide

contains the information to install the required USB drivers, X-Edit editor/librarian and

Pro Tracks recording software for use with the RPx400. Please follow these

instructions carefully to ensure smooth installation of each of these components.

A. Installing Pro Tracks

1. Start your computer. Close any open programs you have running. Place the Pro

Tracks CD-ROM in your CD-ROM drive.

2. If you have autorun enabled, the Pro Tracks installation menu opens automatically,

showing you several buttons. If the menu does not appear automatically, you can

open it by selecting Start>Run and entering d:\Autorun.exe (where d:\ is the

letter of your CD-ROM drive).

3. Click the Install Pro Tracks button and follow the installation instructions on the

screen. If DirectX 8.1+ is not installed, the installer will automatically install it for

you. If DirectX is installed at this time, you will need to restart your computer and

return to Step 1.

NOTE: If you exit Setup without completing the installation, choose Start>Run, type

d:\Autorun.exe (where d:\ is your CD-ROM drive), and click OK. This will reopen

the installation menu. Click Install Pro Tracks to start installation again.

4. When the Installation Complete window appears deselect Launch Pro Tracks

and Read Me check boxes and click Finish.

5. Click Exit from Pro Tracks Installation screen.

B. Installing DigiTech USB Drivers

You must install the USB drivers to use the RPx400's USB connection with your

computer. There are different installation procedures for Windows XP users and

Windows 2000 users. Follow the directions in the section that applies to your

operating system.

Windows XP Users

1. Take the RPx400 out of the box and plug the power in.

2. Remove the USB Warning sticker covering the RPx400's USB port.

3. Connect the included USB cable to your computer and to the RPx400.

4. You will see multiple messages pop up from the task bar indicating that your

computer has found a new USB device. There are multiple messages because there

are four USB devices in the RPx400, two MIDI devices and two audio devices.

5. Wait until Windows has found and identified all of the USB devices from the

RPx400. When the message "Your new hardware is installed and ready to use"

appears,Windows has completed identifying your new hardware. however,

installation of the software IS NOT complete.

6. Put the X-Edit software CD into your CD-ROM drive. The installation menu should