- ページ 30
会議システム Cisco TelePresence System Codec C40のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco TelePresence System Codec C40 46 ページ。 Telepresence c series
telepresence mx series
telepresence sx series
telepresence ex series
Cisco TelePresence System Codec C40 にも： ユーザーマニュアル (44 ページ), スタートマニュアル (42 ページ), トラブルシューティングマニュアル (37 ページ), ユーザーマニュアル (48 ページ)
ページを印刷する
Cisco TelePresence Video Systems
Contents
IP settings
(When not set by a provisioning system)
The IP parameters can be assigned automatically by the
network, or you can set everything manually. If your system
is provisioned automatically, these IP settings may be overrid-
den by the provisioning system.
If you want to set the parameters manually, please contact
your network administrator to obtain the required parameters.
If an IPv4 address is already assigned to the system, you will
find it under Settings: Navigate to the user name in the upper
left corner and select
Settings.
To change the IPv4 settings, navigate to the user name in the
upper left corner and select Settings. Select
and proceed to the IPv4 section.
If you wish to change the IP settings from the default dual
stack setting to either IPv4 or IPv6, this can be done on the
web interface.
NOTE:
When you start up the SX10 for the first time, the
Setup assistant starts automatically.
Back to task overview
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Introduction
User interfaces
1.
Choose automatic or manual IP assignment
Select
DHCP
assignment; or
manually.
Setup
Assistant,
2.
If IP Assignment is Static: Set the IP addresses
Enter the
A soft keyboard appears when you select an input field.
Select
⎷
to confirm the change.
3. Select
Apply
Configuration
Configuration
in the
IP Assignment
section for automatic IP
Static
if you want to set the IP addresses
IP
Address,
Subnet Mask
and
Gateway
to save the changes.
30
Appendices
address.
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts