- ページ 21
会議システム Cisco TelePresence System Codec C90のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco TelePresence System Codec C90 46 ページ。 Telepresence system
Cisco TelePresence System Codec C90 にも： ユーザーマニュアル (44 ページ), マニュアル (25 ページ), スタートマニュアル (42 ページ), トラブルシューティングマニュアル (37 ページ), 設置マニュアル (2 ページ), ユーザーマニュアル (48 ページ)
ページを印刷する
Cisco TelePresence Video Systems
Contents
Setting date, time and location
(When not set by a provisioning system)
When setting up your video conference system, you should
check that the date and time settings are correct. Among other
things this information is used to time stamp messages transmit-
ted to gatekeepers and other network elements.
The time and date is shown in the top right corner of the main
display. It takes a few moments before the time on the screen
changes after changing the setup.
Always save the new value when you change a setting
• Drop down list selection: Navigate to the correct value
and press the
OK
( ) key to save, or press the left arrow
key
to leave without saving.
• Text entry in an input field: Enter the text, navigate to
Ok/Save
to save the change, or navigate to
to leave without saving; then press the
confirm.
Back to task overview
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Introduction
User interfaces
1. Go to
Home > Settings > Date and
2. Select
24 hours
drop down list as you prefer.
3. Select Day.Month.Year,
in the
Date format
4. Select your time zone from the
5. Select Auto,
as you prefer.*
a. If you select Manual, also enter the
in the corresponding input field.
b. If you select
Month,
lists.
6. Press
Home
Cancel
OK
( ) key to
* NTP mode:
Auto: The time is regularly updated using an NTP server. The NTP server
address is automatically obtained from the network (DHCP).
Manual: The time is regularly updated using an NTP server. You must
manually enter the NTP server address.
Off: You must set the time manually. The time is not updated automatically.
Configuration
Configuration
time.
or
12 hours (am/pm)
in the
Time format
Month.Day.Year
or
Year.Month.Day
drop down list as you prefer.
Time zone
drop down list.
Manual
or
Off
in the
NTP mode
drop down list
NTP server
address
Off,
also select the correct value for Day,
Year
and
Time
in the corresponding drop down
(
) to exit.
21
Getting Started Guide
Appendices
Contacts
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.