- ページ 43
会議システム Cisco TelePresence System Codec C90のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco TelePresence System Codec C90 46 ページ。 Telepresence system
Cisco TelePresence System Codec C90 にも： ユーザーマニュアル (44 ページ), マニュアル (25 ページ), スタートマニュアル (42 ページ), トラブルシューティングマニュアル (37 ページ), 設置マニュアル (2 ページ), ユーザーマニュアル (48 ページ)
ページを印刷する
Cisco TelePresence Video Systems
Contents
SX10 on-screen menu
Settings, Standby
mode and Do Not
Disturb feature
Place
Share
calls
content
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Introduction
User interfaces
Camera Control
To gain access to the Settings menu, move cursor to upper
left corner of the screen and press
Then navigate down to Settings and press
Configuration
The Settings shows the basic system information. In addition
OK
on the remote control.
it provides access to the Setup assistant and to restart the
OK
again.
system.
On the Setup assistant you can set the following:
43
Getting Started Guide
Appendices
Appendices
• Language: Select a language for the user interface.
•
IP
settings: Change the IPv4 settings, if those have not been
configured by autoprovisionig.
•
Provisioning
settings: Change provisioning settings, if those
have not been configured by autoprovisionig.
•
Test
microphone: If you are using an external microphone,
use this test to adjust its location.
•
Speaker
volume: Set the speaker volume for ring tones
and calls. If you cannot hear the test sound, check that
the volume on you monitor is switched on, and that the
cabeling is correct.
•
Default camera position:
Set the default camera position
for future calls.
•
Test
presentation: Connect your computer to the SX10, and
wait for the icon to change and mirror your computer screen.
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
Contacts