- ページ 9

会議システム Cisco UC500 seriesのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Cisco UC500 series 50 ページ。 Sip trunking unified communications 500 series

4 Configuration

The UC500 may be configured with either the Cisco Configuration Assistant

(CCA) or command line interface (CLI). This guide documents the CCA

configurations tasks as far as possible with CLI used only to customize the

template further to work with the provider.

4.1

Please refer to the "Getting Started Guide" located at

http://www.cisco.com/en/US/products/ps7293/products_getting_started_guide091

86a0080824095.html

ports. To summarize:

• Connect the "WAN" port to the same Ethernet segment as the inside

interface of the Managed Access Router. This may be accomplished

either with a crossover cable or with a LAN switch.

• Connect IP phones to the FastEthernet ports on the front of the UC500.

•

PCs should generally be connected to the switch port on the phones.

• Any analog devices (such as faxes) may be connected to the FXS ports on

the UC500.

Install CCA on a PC connected to one of the FastEthernet ports on the front of the

UC500. Make sure this PC is configured for DHCP to receive an IP address from

UC500.

4.2

If the UC500 platform has been configured for testing or other purposes prior to

the customer installation, be sure to reset it to the factory default configuration.

UC500 ships with the factory default configuration files on its compact flash, for

example "UC500-16U-4FXO-K9-factory-4.2.5.cfg". The exact name of this file

depends on the UC500 model but the procedure to restore the configuration to the

factory default is the same: Using a console connection, copy this file to the

startup-config in NVRAM. For example:

UC500#copy flash:UC500-16U-4FXO-K9-factory-4.2.5.cfg startup-config

Destination filename [startup-config]?

[OK]

11553 bytes copied in 2.340 secs (4937 bytes/sec)

UC500#

Then reload the UC500.

for instructions about physically connecting the UC500's