- ページ 13

アクセサリー DigiTech JAMMAN - MANUAL 2のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DigiTech JAMMAN - MANUAL 2 20 ページ。 Remote foot controller

Selecting Presets

To select a preset in 5 Patch or 10 Patch Mode, follow these steps:

Press one of the footswitches numbered 1-5 (footswitches numbered 1-

10 in 10 Patch Mode). The associated footswitch LED will light and the

preset name and number will appear in the Display.

To select another preset, press another of the footswitches numbered

1-5 (footswitches numbered 1-10 in 10 Patch Mode). The previous

footswitch LED will turn off and the newly pressed footswitch's LED will

now light.

In 5 Patch Mode, as different presets are selected, different effect footswitch

LEDs (Footswitches 6-10) will turn on and off based on the status of these

effects in the active preset.

To bypass an active preset, press the active preset footswitch. The Display

will read BYPASS when the preset is bypassed and the preset footswitch you

bypassed from will remain lit (in 5 Patch Mode, the effects footswitches that

were on before bypassing will also remain lit). To return to the same preset

from bypass, press the lit preset footswitch again and the last preset loaded

will become active again.

You can also change to another preset from bypass by pressing any non-lit

preset footswitch. In 5 Patch Mode, you can also turn any of the effects

(DISTORTION, CHORUS/FX, DELAY, REVERB) on or off when exiting bypass

by pressing one of these footswitches instead of a preset footswitch. This

will load the last active preset and turn the respective effect on or off as it is

loaded.

NOTE: Bypassing presets with the footswitches is not available if the Bounce

Back feature is enabled. Refer to the Bounce Back section on page 8 for

more information about the Bounce Back feature.

In 5 Patch Mode, Footswitches 6-9 are programmed to turn on or off the

following effects in the active preset:

Footswitch 6 controls the Distortion on/off.

Footswitch 7 controls the Chorus/FX on/off.

Footswitch 8 controls the Delay on/off.

Footswitch 9 controls the Reverb on/off.

Footswitch 10 can also be programmed to turn on and off effects as

well. See page 11 for more information about assigning effect on/off and

parameters to the CONTROL footswitch).

Using the Control 2 Remote Foot Controller

Control 2 Owner's Manual