- ページ 7

エアコン Argo POLIFEMO BEARのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo POLIFEMO BEAR 9 ページ。 Evaporative air cooler

COOL BUTTON

Press this button on the control panel to activate the cooling function. When the COOL LED flashes on the control panel,

it means that the water level in the tank is below the minimum, therefore it is necessary to add water into the tank.

SWING BUTTON

Press this button on the control panel or on the remote control to activate the automatic vertical oscillation of the air flaps.

To deactivate this function, press this button again. It is possible to manually adjust the flaps horizontally, to direct the air

flow where desired.

THE TANK MUST BE FILLED WITH DEMINERALIZED WATER FOR THE APPLIANCE TO

OPERATE IN COOLER/HUMIDIFIER MODE.

The water is inserted directly into the rear tank. Before introducing the water, check that there are no water residues inside

the water pump, to prevent its leakage.

Fill the tank up to the maximum level marked on the water indicator, without exceeding the water level limit, this could cause

water

leakage.

If you wish to keep the water in the tank below room temperature in order to maximize cooling in warmer months, leave the

two synthetic ice packs supplied in the freezer until solid, then add them to the water in the tank.

The ice will absorb heat from the water.

With the unit off, place the ice packs directly in the tank in the position shown in the figure, inside the tank there is a special

space where to place the ice packs. Make sure that the tank can be pulled out normally.

We recommend continuous use of the ice for optimal cooling capacity.

Ice packs can be used repeatedly.

The first time it is used, you may detect a smell or the water may turn an unusual color: this does not constitute a health risk.

WARNING: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE

PROCEDURES. IMPORTANT: DO NOT SUBMERGE THE PRODUCT IN WATER

Cleaning the outside surface of the appliance

Use a soft cloth to remove any dust from the product.

If this is not enough, use a soft cloth dampened with water and a mild detergent at a temperature not exceeding 50°C. Let

the appliance dry completely before using it.

Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. Do not use oils, chemical

substances or other items that may damage the surface to clean it.

Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.

When the appliance is used for a long time, the tank, the tank filter, the honeycomb filter and the dust filter may have

accumulated dust, this could affect the air flow and the effect of cooling. It is therefore advisable to clean these parts every

two weeks.

V 02/22

FILLING THE WATER TANK