- ページ 4

エアコン Argo SDIBS9DCのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Argo SDIBS9DC 19 ページ。 Split air conditioner system
Argo SDIBS9DC にも：取扱説明書 (15 ページ), 取扱説明書 (17 ページ)

1 - INSTALLATION SITE SELECTION

AVOID

• Direct sunlight.

• Nearby heat sources that may affect unit performance.

• Areas where leakage of flammable gas may be expected.

• Locations where large amounts of oil mist may occur

(such as in kitchen or near factory equipment) because

oil contamination can cause operation problems and may

deform plastic surfaces and parts of the unit.

• Unsteady locations that will cause noise or possible

water leakage.

• Locations where the indoor unit and the remote control

unit will be splashed with water or affected by dampness

or humidity.

• To make holes in areas where electrical wiring or conduits

are located

SEE INSTALLATION INSTRUCTIONS OF OUTDOOR UNIT

Connecting wire B (SHIELDED):

Bipolar electric shielded wire; size and length of the suggested electric wire are showed on table "electrical data"

(Outdoor unit). The wires have not to be lighter than Mod. H05VVC4V5-K (according to CEI 20-20 CENELEC HD21).

Connecting wire C (with ground conductor):

Multipolar electric wire; size and length of the suggested electric wire are showed on table "electrical data"

(Outdoor unit). The wires have not to be lighter than Mod. H07RN-F (according to CEI 20-19 CENELEC HD22). Make

sure the length of the conductors between the fixing point and the terminals allows the straining of the conductors

L, N before that of the grounding.

TP1

TP2

• Select an appropriate position from which every corner

of the room can be uniformily cooled.

• Select a sufficiently strong location to support the weight

of the unit.

• Select a location where tubing and drain hose have the

shortest run to the outside.

• Allow access for operation and maintenance as well as

unrestricted air flow around the unit.

TO OUTDOOR UNIT