- ページ 9

エアコン Argo snappyのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo snappy 12 ページ。 Local air conditioner

ページを印刷する

Decrease (▼):

1) Enables the adjustment of the temperature desired in Cooling and Heating modes

2) Each time the (▼) button is pressed, the temperature set decreases by 1ºC; by holding the button pressed, the

temperature decreases continuously.

(6) FUNCTION DISPLAY

The display shows the temperature and the set timer. When the temperature and timer are set, the new

temperature will be displayed for a few seconds, then the display shows again the room temperature.

This display detects also errors:

Problem

Cause

E1 – E2

Defective temperature sensor or PCB.

Tank full or plug not correctly fitted.

(7) SPEED BUTTON

Press this button when the appliance is on in order to set the fan speed in cooling mode.

High fan speed: the LED HI will switch on

Medium fan speed: the LED MID will switch on

Low fan speed: the LED LO will switch on

When the LED AUTO switches on the air conditioner regulates automatically the fan speeds on the 3 possible levels.

On the remote control there are three buttons:

high speed

In heating mode the speed is automatically settled at the maximum value and in dehumidification mode at the

minimum

value.

(8) TIMER OFF BUTTON

Press this button when the appliance in order to set the time remaining before the unit is switched off can be set:

•

Select a number of hours from "1" to "24".

•

Press the TIMER button consecutively and the number of hours increases by 1 each time it is pressed, up to 24.

•

Press the Power button

(9) SLEEP BUTTON

1) By pressing the button once, the unit enters "sleep" mode and the indicator on the control panel lights up; by

pressing the button a second time, the unit leaves sleep mode and the indicators turns off.

2) When activating the SLEEP function in Cooling mode, the temperature set increases automatically by 1ºC every

hour for the next 2 hours: it then remains stable for the rest of the time.

3) When activating the SLEEP function in Heating mode, the temperature set decreases automatically by 1ºC every

hour for the next 2 hours: it then remains stable for the rest of the time.

4) Each time the air conditioner is switched off, SLEEP mode is cancelled. To restore, simply press the SLEEP button

once.

REMOTE CONTROL BATTERY

Insert the battery into the remote control, respecting polarities specified.

Only use type CR2025 batteries 3 V Li, in accordance with European Directive 2006/66/EC (supplied with the remote

control).

Remove the battery if the remote control is not used for a month or longer.

Do not attempt to recharge the battery.

Do not throw the battery onto a fire, it may explode.

V 11/13

medium speed

low speed.

(AUTOMATIC SHUTDOWN)

before the time expires and the setting will be cancelled and unit will switch off.

Solution

Contact the service centre.

Empty the tank. Check that the plug is fitted

correctly into the socket. Then press POWER

button