- ページ 24

ネットワーク・ハードウェア Cisco 3110のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 3110 42 ページ。
Cisco 3110 にも：はじめに (42 ページ)

Power Supply Module

For More Information

Power Supply Module

See

Product ID Numbers, on page 33

supply modules.

Note

Attention

Note

AC Power Supply

The dual power supplies can supply up to 800-W power across the input voltage range. The load is shared

when both power supply modules are plugged in and running at the same time.

Overview

Power LED

Six network activity LEDs:

• Amber—No connection, or port is not in

use, or no link or network failure.

• Green—Link up, no network activity.

• Green, flashing—Network activity.

• See

8-Port 10/100/1000Base-T Network Module with Hardware Bypass, on page 19

of the 1-Gb network module.

• See

8-Port 1/10/25-Gb Network Module, on page 15

module.

• See

4-Port 40-Gb Network Module, on page 17

• See

Install, Remove, and Replace the Network Module

network modules.

You cannot mix AC and DC power supply modules in the chassis.

After removing power from the chassis by unplugging the power cord, wait at least 10 seconds before turning

power back ON. You want to keep the system power off, including the standby power, for 10 seconds.

Make sure that one power supply module is always active.

The system power requirements are lower than the power supply module capabilities. See the following table.

Handle ejector

—

for a description of the 1/10/25-Gb network

for a description of the 40-Gb network module.

for the procedure for removing and replacing

for a list of the PIDs associated with the Secure Firewall 3100 power

Overview

for a description