- ページ 7
ビデオカメラ Sony XCGH280EのPDF テクニカル・マニュアルをオンラインで閲覧またはダウンロードできます。Sony XCGH280E 46 ページ。 Digital video camera module
Sony XCGH280E にも： パンフレット (2 ページ)
ページを印刷する
Location and Function of Parts and Operation
Front/Top/Bottom
a Lens mount (C-mount)
Attach any C-mount lens or other optical equipment.
Note
The lens must not project more than 10 mm (13/32 inch)
from the lens mount.
1 Lens mount face
b Guide screw holes (Top)
c LED light screw holes
Use these screw holes to attach the LED light to the
camera module.
Use an adapter appropriate for the LED light as required.
d Guide screw holes/Tripod screw holes (bottom)
These precision screw holes are for locking the camera
module. Locking the camera module into these holes
secures the optical axis alignment.
When using a tripod, use these four screw holes to attach
a VCT-ST70I tripod adaptor.
Note
Use the screws (M3 × 8 (4)) supplied with the tripod
adaptor when installing it on the camera module.
For More Information Please Call Aegis Electronic Group, Inc. * (888) 687-6877 Phone * [email protected] * http://www.aegis-elec.com
2 10 mm (13/32 inch) or less
Rear
1
2
3
2 WIRING
CLASS
DC 12V
1 2 3 4 5 6 7
1000BASE-T
e DC 12V (DC power input) connector
Connect the DC power cord to input the +12 V DC
power supply.
The pin configuration of this connector is as follows.
Pin No.
+
+12V
–
GND
f I/O (Input/Output) connector
Pin No.
1
GPO[1]
2
GPO[2]
3
TRIGGER IN[1]
4
TRIGGER IN[2]
5
GPI[1]
6
GPI[2]
7
GND
g RJ45 connector
You can connect a LAN cable to this connector to
control the camera module from a host device to output
image to a host device.
Pin No.
Signal
1
TP1 +
2
TP1 –
3
TP2 +
4
TP3 +
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
8
7
6
5
4
3
2
1
4
5
6
7
I/O
Signal
Signal
Pin No.
Signal
5
TP3 –
6
TP2 –
7
TP4 +
8
TP4 –
7