- ページ 5

ネットワーク・ハードウェア Cisco 5500 SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 5500 Series 19 ページ。 Cisco 8500 series wireless lan controller
Cisco 5500 Series にも：設定マニュアル (40 ページ), インストレーション・マニュアル (34 ページ), 設定マニュアル (50 ページ)

ページを印刷する

1. Replacing Hardware Components

Chapter 7

Maintaining the Cisco Catalyst 5500 Multiswitch Router

Table 7-4

LED

STATUS

CPU HALT

ENABLED

PCMCIA

SLOTs 0 and 1

1. TX = transmit

2. RX = receive

3. ms = milliseconds

Using the Command Line Interface to Check Status

The Cisco Catalyst 5500 command line interface includes a series of commands that enable you to

determine if the MSR is functioning correctly or where problems have occurred. Relevant commands for

checking status include ping, traceroute, test snmp trap, and show. There are more than 100 show

commands, many of which can be used to check status. To learn how to find more information

concerning these and other commands, refer to the Command Reference Manual that came with the

Cisco Catalyst 5500 MSR.

Replacing Hardware Components

This section describes how to perform the following removal and replacement procedures for

Cisco Catalyst 5000 series field-replaceable units (FRUs):

•

For instructions on installing and replacing switching modules, refer to the Catalyst 5000 Series Module

Installation Guide.

OL-0542-06

RSM (WS-X5302) STATUS LED Descriptions

State

Green

Red

Orange

Off

Green

Removing the Supervisor Engine, page 7-6

Using Flash Memory (PCMCIA) Cards (Supervisor Engine III), page 7-7

Removing and Replacing the Power Supply, page 7-8

Removing and Replacing the Chassis Fan Assembly, page 7-15

Cisco MGC Software Release 7 Operations, Maintenance, and Troubleshooting Guide

Description

All the self-tests have been passed.

A test other than an individual port test has been failed.

System boot, self-test diagnostics running, or the module is disabled.

Indicates normal RSM operation.

The system detected a processor hardware failure.

Indicates IP microcode is loaded and the RSM is operational.

Indicates PCMCIA devices in slot 0 and 1 are being accessed by the

RSM.

The port is transmitting a packet (LED is lit for approximately 50 ms).

The port is receiving a packet (LED is lit for approximately 50 ms

Replacing Hardware Components

)

7-5