- ページ 4

ネットワーク・ハードウェア Cisco 6015のPDF 取り付けと交換に関する注意事項をオンラインで閲覧またはダウンロードできます。Cisco 6015 18 ページ。 Dsl interface module fru
Cisco 6015 にも：クイック・リファレンス・マニュアル (38 ページ)

ページを印刷する

Part and Tool Requirements

Table 2

Check

Part and Tool Requirements

lists the tools and equipment that you need to install and remove a DSL interface module.

Tool and Equipment Requirements Checklist

Tools and Equipment

Hardware Components and Cables

DSL interface module.

Equipment necessary for ESD protection—You need this equipment whenever you handle

Cisco chassis, modules, and cards.

One of the following cables for POTS splitter connections.

•

Wye-cable for DSL interface module to Corning Cable Systems POTS splitter

connection (72-1973-01) or equivalent.

•

Wye-cable for DSL interface module to ADC POTS splitter connection (72-1973-01)

or equivalent.

24 AWG, 25-twisted pair, solid core shielded telco cable with shielded RJ21X

•

(Champs) connector.

The wye-cable is used only with quad-port xTU-C line cards.

Note

Unshielded cable cannot be used in an FCC/CISPR Class B

compliance environment. If unshielded cable is used for FCC Class A or EN55022

Class A compliance, ferrites are needed.

24 AWG, 25-twisted pair, solid core shielded telco cable with shielded RJ21X (Champs)

connector

for MDF connections.

Note

If unshielded cable is used for FCC Class A or EN55022 Class A compliance,

ferrites are needed.

Ferrites that yield an impedance of 53 ohms at 25 MHz and 177 ohms at 100 MHz are to be

used under the following conditions:

•

Cisco 6015 to POTS splitter connection — If unshielded cable is used for FCC Class A

or EN55022 Class A compliance, ferrites are needed.

•

Cisco 6015 to MDF — If unshielded cable is used for FCC Class A or EN55022 Class A

compliance, ferrites are needed.

Equipment necessary for ESD protection—You need this equipment whenever you handle

Cisco chassis, modules, and cards.

Tools

Phillips-head or flat-head screwdriver.

Two Champ connector screws.

Tie wraps.

Software Components

Cisco IOS or CDM

See

Table 1

for minimum software and network management release requirements.

Note

OL-2186-01