- ページ 18

ネットワーク・ハードウェア Cisco 6160のPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 6160 21 ページ。 Without a pots splitter configuration
Cisco 6160 にも：クイック・リファレンス・マニュアル (38 ページ), 取り付けと交換に関する注意事項 (18 ページ), インストール手順マニュアル (32 ページ)

ページを印刷する

Unpacking the Cisco 6160 System

Table 2-4

Check

1. SMF = single-mode fiber

2. MMF = multimode fiber

3. MDF = main distribution frame

4. BITS = building integrated timing supply

5. AWG = American Wire Gauge

6. UTP = unshielded twisted pair

7. STP = shielded twisted pair.

8. CDM = Cisco DSL Manager

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

2.4 Unpacking the Cisco 6160 System

Each Cisco 6160 system chassis is securely packaged in a shipping box. The Cisco 6160 ships with the

line cards and the NI-2 card(s) installed in the chassis.

Caution

Proper ESD protection is required whenever you handle Cisco equipment. Installation and maintenance

personnel should be properly grounded by means of grounding straps to eliminate the risk of ESD

damage to the equipment. Equipment is subject to ESD damage whenever it is removed from the chassis.

Warning

Two people are required to lift the chassis. Grasp the chassis underneath the lower edge and lift with

both hands. To prevent injury, keep your back straight and lift with your legs, not your back.

To unpack the Cisco 6160 system, complete the following steps:

Inspect the packing containers. If any damage or other signs of mishandling are evident, inform both the

Step 1

local freight carrier and Cisco before unpacking. Your freight carrier can provide you with the

procedures necessary to file a claim for damages.

Step 2

Carefully open the box.

Step 3

Remove all packing material.

Remove the chassis from the box.

Step 4

Cisco 6160 Hardware Installation Guide

2-18

Tool and Equipment Requirements Checklist (continued)

Tools and Equipment

Software Components

Cisco IOS or CDM

See

Appendix A, "Technical Specifications"

Note

management release requirements per Cisco 6160 chassis component.

Chapter 2

Preparing for Installation

for minimum software and network

OL-2190-02 B0