- ページ 20

ネットワーク・ハードウェア Cisco 6160のPDF インストール手順マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 6160 32 ページ。 Without a pots splitter configuration
Cisco 6160 にも：クイック・リファレンス・マニュアル (38 ページ), ハードウェア・インストール・マニュアル (21 ページ), 取り付けと交換に関する注意事項 (18 ページ)

Installation Procedures

To establish APS link redundancy repeat

Step 4

Repeat

Step 5

4.2.10.3 T1 or T1 IMA Subtending Connections

Complete the following steps to connect the TI or TI IMA subtending connections:

For more information about T1 or T1 IMA subtending connections, see the

Note

Configuration with DS3+T1/E1 IMA NI-2 Cards" section on page

Verify that the DS3+T1/E1 IMA NI-2 card is installed in slot 10 (or slot 11, if a secondary NI-2 card is

Step 1

installed for redundancy) and the DS3/2DS3+8xT1 IMA I/O card is installed on the chassis backplane.

Note

Connect one end of an RJ-48 cable to one of the RJ-48c receptacles on the DS3/2DS3+8xT1 IMA I/O

Step 2

card located on the subtending host chassis backplane.

Figure 4-12

Note

Cisco 6160 Hardware Installation Guide

4-20

Step 1

through

Step 4

for each subtending host chassis.

See the

"Redundancy in Subtended Configurations" section on page 1-42

about redundant configurations.

shows the cabling for a T1 or T1 IMA subtended network configuration.

See

Table 2-4

for cable specifications. See

Chapter 4

Installing a Cisco 6160 Without a POTS Splitter Configuration

Step 2

and

Step 3

for a secondary OC-3c/OC-3c NI-2 card.

1-7.

Figure 1-19

for T1 interface locations.

"Subtended Network

for more information

OL-2190-02 B0