- ページ 4
除湿機 Argo DRY BABY 11のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo DRY BABY 11 6 ページ。
Argo DRY BABY 11 にも: 取扱説明書 (8 ページ), 取扱説明書 (10 ページ)
APPLIANCE STARTUP
Place the product on a flat and stable heat-resistant surface, at least 1 metre away from
flammable or heat-sensitive materials and 50 cm away from walls or other obstructions.
Make sure the water tank is in the correct position.
Connect the power cord to a suitable electric socket (230V).
Press the button ON/OFF on the control panel.
The OPERATION LED (C), which indicates dehumidifier operation, will light up.
OPERATING PRECAUTIONS
The dehumidifier adjusts the humidity level automatically and stops working only when the tank is
full and you have not set the continuous condensate drainage.
In this case, empty the tank and reposition it correctly: the dehumidifier will start running again.
WARNING:
After every interruption in operation, at least 3 minutes must pass before the dehumidifier starts
running again: this delay in start-up protects the compressor from potential damage.
If, after following the appliance start-up instructions, the dehumidifier does not start and the
operating light does not come on, or if the dehumidifier stops for no reason, make sure the plug and
power cord are in good working order.
After doing so, wait for 10 minutes and then restart the appliance.
If the dehumidifier still does not start after 10 minutes, or if either the power cord or plug is
damaged, switch off the appliance and contact an after-sales service centre.
WARNING:
When the dehumidifier is running, the compressor produces heat and the appliance emits warm air
into the room. The room temperature will therefore tend to increase.
This is completely normal.
TANK FULL ALARM LED (A)
When the tank is full of condensate, the TANK FULL alarm LED(A) turns on
and the appliance stops running.
Remove the tank and empty it, then reposition it correctly: the
appliance will resume operation.
DEFROST LED (B)
The appliance can operate correctly at a room temperature between + 5°C and + 32°C.
When the appliance is operating at a low room temperature (under 12°), ice may start to form on
the surface of the evaporator; this could reduce overall dehumidifier efficiency.
When this occurs, the appliance switches to defrost mode and the DEFROST LED (B) comes on.
We recommend the dehumidifier is not used if the room temperature is lower than 5°C.
SWITCHING THE APPLIANCE OFF
To switch the dehumidifier off, press the button OFF on the control panel again.
The power supply is cut off and the appliance stops running.
Unplug the appliance if you do not intend to use it for some time.
V 02/13
OPERATING INSTRUCTIONS
Use both hands when
emptying the water tank
10