ページを印刷する
To turn the dehumidifier off press the POWER button. This shuts off power to the unit.
Unplug the appliance if you do not intend to use it for some time.
The water extracted from the air can be collected in the provided front tank.
When the tank is full, not inserted or not correctly inserted, the FULL TANK led turns on and the unit beeps for about 10
seconds, at the end of which the unit turns off.
To switch off the appliance, press the POWER button and wait a few seconds.
1. Carefully pull out the tank, following the direction of the arrow.
2. Empty the tank and dry it thoroughly.
3. Reposition the tank
4. Press the POWER button again to turn on the unit.
NB: If the full tank LED remains lit even after emptying the tank, check that the float, which is inside the tank, is correctly
positioned.
Make sure not to damage the float and the locking rivet, which are inside the tank, otherwise the unit will not
automatically stop working when the water tank is full, and the water could leak out and risk wetting the tank. floor and
damage the appliance.
N.B. Do not use the drainage pipe when you want to collect the condensate in the tank, otherwise the water could come
out from the pipe.
The water can be continuously drained when using a PVC hose with an inner diameter of 11 mm (supplied).
Turn off the appliance and remove the plug before connecting the hose.
Connect the tube to the condensate drain hole securely and prepare a container that can hold the water. The tube must
be connected without bends or bends, to facilitate an easy drainage of the condensate, and must be positioned at a
greater height than the drain hole.
When disconnecting the hose, prepare a container to collect any residual water that may leak out of the hose.
V 02/22
TURNING THE DEHUMIDIFIER OFF
HOW TO ELIMINATE CONDENSATE
CONTINUOUS CONDENSATE DRAINAGE
22