- ページ 15

計測機器 ACU-RITE SENC 150のPDF リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。ACU-RITE SENC 150 20 ページ。 Chevalier fsg-2a 1224 surface grinder cross feed “x” axis
ACU-RITE SENC 150 にも：インストレーション・マニュアル (8 ページ), インストレーション・マニュアル (4 ページ), インストレーション・マニュアル (6 ページ), 取扱説明書 (12 ページ)

SENC 150

Leveling screws

Adjust the leveling set screws as follows:

 Insert, but do not tighten 8-32 (M4) reading head screws

as shown on the right side.

 Place a 0.025 mm - 0.075 mm (0.001"- 0.003") shim between

the leveling set screws and mounting surface.

 Adjust each set screw until a slight drag is felt on the shim.

 Remove the shim before tighten the reading head screws.

Mounting the reading head

M3 x 12 mm SHSS

M4 x 25 mm SHCS low head

(8-32 x 5/8" SHCS low head)

(8-32 x 3/4" SHCS low head)

Mounting the reading head with hex nut

M4 hex nut

Do not tighten prior to adjusting leveling set screws.

Evenly tighten the 8-32 (M4) reading head mounting screws.



Removing the alignment brackets

Slide brackets away from reading head and cable.

 Slide the brackets away from the reading head.

 Remove the alignment brackets and save for future use.

7 Mounting the reading head

M4 x 25 mm SHCS low head

(8-32 x 5/8" SHCS low head)

(8-32 x 3/4" SHCS low head)