- ページ 6
ネットワーク・ハードウェア Cisco 8540 - Catalyst Campus Switch Router Modular Expansion BaseのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 8540 - Catalyst Campus Switch Router Modular Expansion Base 11 ページ。 Installing the controller
Cisco 8540 - Catalyst Campus Switch Router Modular Expansion Base にも： トラブルシューティングマニュアル (23 ページ)
ページを印刷する
Installing the Slide Rails
Figure 2: Front Securing Mechanism, Inside of Front End
1
2
Step 3
Install the slide rails into the rack:
a) Align one slide-rail assembly front end with the front rack-post holes that you want to use.
The slide rail front-end wraps around the outside of the rack post and the mounting pegs enter the rack-post holes
from the outside-front (see
The rack post must be between the mounting pegs and the open securing plate.
Note
b) Push the mounting pegs into the rack-post holes from the outside-front.
c) Press the securing plate release button, marked "PUSH." The spring-loaded securing plate closes to lock the pegs in
place.
d) Adjust the slide-rail length, and then push the rear mounting pegs into the corresponding rear rack-post holes. The
slide rail must be level front-to-rear.
The rear mounting pegs enter the rear rack-post holes from the inside of the rack post.
e) Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail assemblies are at
the same height with each other and are level front-to-back.
f) Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops and lock in place.
Step 4
Insert the controller into the slide rails:
Caution
This controller can weigh up to 44 pounds (approximately 20 kilograms) when fully loaded with components.
We recommend that you use a minimum of two people or a mechanical lift when lifting the controller. Attempting
this procedure alone could result in personal injury or equipment damage.
a) Align the rear of the inner rails that are attached to the controller sides with the front ends of the empty slide rails on
the rack.
b) Push the inner rails into the slide rails on the rack until they stop at the internal stops.
c) Slide the release clip toward the rear on both inner rails
continue pushing the controller into the rack until its front slam latches engage with the rack posts.
Installing the Controller
6
Front mounting pegs
Rack post
Figure 2: Front Securing Mechanism, Inside of Front End, on page
3
Securing plate shown pulled back to
open position
(Figure 3: Inner Rail Release Clip, on page
Installing the Controller
6).
7), and then