- ページ 8

ネットワーク・ハードウェア Cisco ACC-7010RMK=のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Cisco ACC-7010RMK= 15 ページ。 Rack-mount and cable management kits

Rack-Mounting the Chassis

Figure 3

If you are installing a new router, mount the chassis in the rack before connecting any interface or

power cables. Otherwise, disconnect all cables before moving the chassis. To help ensure that you

connect the interface cables to their original interface ports, tag each cable with its slot/port address

before you disconnect it.

Installing the Ears on the Chassis

Each chassis ear has two studs that ﬁt into holes in the chassis. The chassis has two pairs of holes on

each side: one pair near the interface processor end and one pair near the noninterface processor end.

(See Figure 4.) Install both ears at the same end of the chassis (either at the interface processor end

or the noninterface processor end), whichever will be in the front of the rack. For example, if you

will install the chassis with the interface processor end of the router at the front and the noninterface

processor end in the back of the rack, install the ears near the interface processor end of the chassis.

To install the ears on the chassis, follow these steps:

Step 1

Step 2

Step 3

8 Cisco 7010 and Cisco 7505 Rack-Mount and Cable Management Kits Installation Instructions

Typical 19-Inch Equipment Rack Posts and Mounting Strips

18.312"

hole C to C

Mounting strips

17.72" min.

Verify that you have all the parts you will need: two chassis ears, four M4 x 10-mm Phillips

ﬂathead screws, and eight 10-32 x 3/8-inch, slotted binderhead screws.

On the rack, measure the space between the inner sides of the left and right front posts or

mounting strips to ensure that it is at least 17.72 inches wide. (The chassis is 17.65 inches

wide with the ears installed and must ﬁt between the mounting strips.)

Refer to Figure 4 and locate the guides in the chassis sides.

Rack posts

110 VAC

outlets