- ページ 12

シュレッダー Argo FX310GのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo FX310G 16 ページ。 Wallner shredders

CAUtION:

it is forbidden to place more sheets of paper then the maximum amount indicated by the

producer.

if the machine will be overloaded, then please proceed according to the information given

in the "paper jam" section.

FEEDING CREDIt CARDS/CDS

1. Plug in the machine.

2. Feed the credit card/ cd into the proper entry and the machine will start automatically

CAUtION:

Never attempt to shred more than one credit card/cd at a time or the shredder will jam.

Never attempt to shred BOTh paper and credit cards/cds at the same time. doing so will

damage the shredder.

mOtOR PROtECtION

The shredder is equipped with a motor overload device.

after 8 minutes of continuous work allow the unit to cool for 50 minutes before restarting.

after cooling down, the shredder is ready to re-start to work. it is crucial to avoid the situ-

ation when the thermal fuse will work - this type of usage of the shredder is not proper and

implies machine's overwork.

CUttER OILING INStRUCtIONS

To ensure proper operation and function, periodic oiling of the cutting system is required.

Failure to oil your cutting system could result in reduced sheet capacity performance,

excess noise, paper jams and possibly machine failure. Oil your cutters every 5th or 6th

time you empty the basket, if excess squeaking and rubbing noise is coming from the

machine or if the shredders sheet capacity has diminished. squeeze the lubricant across

the full width of the cutters. Press the "i" button, insert paper into sensor to activate the

cutting system forward for 3 seconds. Then press „reV" to make shredder reverse for 3

seconds. alternate between forward and reverse at least three times or until all paper

clears the cutters.

CAUtION:

Never use flammable synthetic oil, petroleum based or aerosol lubricants to oil your

cutting system. Use only a vegetable oil based lubricant in a non-aerosol container with

extension nozzle.

BASIC EXPLOItAtION RULES

it is not advised to cut as many shreets as indicated as the maximum capacity of the

shredder. By exploiting the machine at it's top capacity we significantly reduce it's vitality.

Therefore, to maintain a durable and faultless work of the shredder, it is adviced to place

no more then 70% of the maximum amount of sheets to be shred at one time indicated

for each model by the producer. The maximum amount of sheet should be used only oc-

casionally.